Payment & Shipping Terms:
|Socket:||T8-G13,E26/27,El4,MR16,GU10 ,B22/G24 Etc||Dimmer:||Dimmer Switch|
E27 Dimmer Switch LED Suitcase , LED Demo Case For LED Exhibition / show
LED Test Case GEL-SC-7P-1280 LED Demo case LED display kit
On our LED Test Case, the A area is for traditional lamps and B is for LED lamps.
1. LED lamp and traditional lamp can be tested at the same time. (Two LED lamps and one traditional one can be plugged in).contrast can be done in one data display system by using the switch control.
2. Parameters for MR16 can be tested (direct-current power)
3. Parameters for GU10, E14, E26/ E27can be tested (voltage, current, power, power factor, annual current consumption)
4. AC voltage display area: Input voltage can be displayed; support international use; voltage ranges from 86~264V. Overseas voltage can be shown for overseas use.
5. AC current display area: Current can be displayed. The measurement for current is accurate to mA. The accuracy is about 1/1000.the measuring range is 4A.
6. AC power display area: Power can be displayed. Power meter is correct to 1 decimal point. So, it can show the change and contrast of power correctly. The ultimate power is 999.9w. If it surpasses 999.9, it will be showed as HHHHH.
7. Power factor display area: LED power factor can be displayed. (PF is a very important parameter for LED; power factor for traditional lamp is 1)
8. Annual power consumption display area: Annual power consumption can be displayed (ten hours power on per day)
9. Frequency display area: The frequency for relative state grid can be showed. Some frequency abroad is 60Hz.
10. DC power meter: The power of the DC12V lamp can be showed. AC and DC must be designed separately and should never be showed in the same meter.
11. Design for dimmable: Dimmable engine and Dimmable switch; there are two positions for dimmable switch-DIMMBALE and NON-DIMMABLE. When put the switch on dimmable position, the brightness for all dimmable lamps can be adjusted. When put the switch on Non-dimmable position, all the dimmable lamps can’t be adjusted. So it can be tested that if the brightness of the lamp can be adjusted.
12. Two wire clamps (AC output and DC 12 output) and one AC output universal socket. It’s convenient for external power source. Every lamp socket has a unique switch and mark, which is convenient for identification and control.
13. One storehouse is for small things; 3 foundation plates are to protect the case; a pull rode is convenient for moving.
Paper carton, pearl film inside
Dimension after package:
Series: 3521--- 380*220*130MM
Series: 1280 --- 1380*400*230MM
Series: 6833 ---790*400*245MM
Series: 4228 ---450*400*190MM
Applications of Product:
LED exhibition, LED product show, sample test and so on.
LED Test Case, LED Demo Case, LED display Case, LED Show Case, LED Test Suitcase, LED Demo Suitcase